AD-4532B

PDF Brochure (PDF 1,142KB)

PDF Manual (PDF 1,11MB)

REQUEST A QUOTE

 

Category:

Description

Features

  • New Tricolor (Orange, Green & Red) LED Display
    Highly visible easy-to-read display

 

 

 

 

 

 

  • Enhanced comparator functions
    In addition to a simple comparison of the upper/lower limit, the AD-4532B is equipped with a 2D comparator function that shifts between the upper/lower limit in five levels using a time control or an external signal

  • 2D (5-level) comparator function
    This function makes it possible to determine the
    acceptability of the total result by performing a sequential
    comparison while shifting between the upper/lower limit in five levels using a time axis or an external input (trigger). It is ideal for use in measurements, such as a press-in operation, which require changes in the comparison value as time elapses. The five comparators can also be used individually.
  • High-speed A/D*1 and D/A*2 conversion function at 2000 times/sec.
    *1 Analog-to-digital conversion *2 Digital-to-analog conversion
  • Calibration without an actual load
    The digital span calibration function makes it possible to perform a calibration by entering the rated output (mV/V) of the sensor
    using the numeric keys. This function is useful when an actual load cannot be applied.
  • Latching function
    The display, the comparator output and the D/A voltage output can be latched (data output hold).
  • Relay output with a long-life MOSFET relay
  • Chatter-prevention function
    If bouncing of the comparator value occurs repeatedly near the upper/lower limit, a heavy burden will be placed on the relay
    circuit and other parts. To prevent this, the AD-4532B has a function to set the hysteresis width and time

 

 

 

 

 

 

 

 

  • Hold Function

The hold mode can be activated using the front panel key,
a Modbus-RTU, or the external input terminal on the rear
panel.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  • Wide variety of data input/output

The AD-4532B comes equipped with an analog amplifier voltage output (±10V), a D/A analog voltage output (±10V),
a comparator output and a Modbus-RTU input/output. In addition, we offer an optional BCD output, RS-232C input/output,
D/A analog voltage/current output (±10V / 4 to 20mA) and Ethernet. The upper/lower limit setting, the zero compensation
function and the hold function can be executed via Modbus-RTU.

 

 

 

 

 

 

 

 

 

 

 

Specifications

 

 

 

 

 

 

 

 

 

 

 

 

 

  • Functions (Standard)

 

 

 

 

 

 

 

  • General specifications

 

 

 

 

 

Options

AD4532B-01* – BCD output (40-pin FCN connector)
AD4532B-04 – RS-232C (D-sub 9 pin)
AD4532B-07* – D/A analog voltage/current output (±10V and 4~20mA)
AD4532B-08 – Ethernet interface (RJ-45)
*Options 01 and 07 are provided with each connector.
Note: Options 01, 04, 07 and 08 above cannot be used at the same time.

Appearance and/or specifications subject to change for improvement without notice.